11 Steps to Spray Paint Your Car Like the Professionals - Car Bodywork Paint Repair - accidentalface733's Blog

accidentalface733

accidentalface733

11 Steps to Spray Paint Your Car Like the Professionals - Car Bodywork Paint Repair

Posted

You may be surprised to see just how you can spray car paint actually can not be difficult. That doesn't mean that you can just grab a tin of paint and go at it. There are some basics you must understand. Both in application and the preparation.

Step A:

Prepare by assembling all of your items that you're going to need. Any parts that do not need to be sprayed and that can be removed afterward do so.

Measure B:

You'll have to analyze the car carefully for any rough spots. This will smooth out the rough spots. It also enables the aerosol car paint to adhere better. Once you have finished sanding, make sure all of the dust soil and debris are taken off the vehicle. It's imperative the automobile be perfectly clean.

Measure C:

This will make sure that you get an overall even coating of your colored paint plus helps the paint to adhere nicely. When you spray on the primer, ensure you apply light coats and allow for drying in between. The way to spray car paint takes a little getting used to.

Step D:

Now you might be well to the point at which you happen to be about ready to spray on the shade. In either case, make a few practice strokes on an object before you begin with the car. After you're ready, start the passes with the paint without reluctance. You'll get uneven coverage, if you hold the spray can or gun in one area and perhaps the paint will run. If this happens you have a major repair job on your had. You'll most likely have instructions regarding the best way to spray on car paint using Alloy Wheel Refurb Enfield the gear or spray cans.

Step E:

It's up to you whether you need to wet sand between coats of color and primer paints. You might want to study this option on the internet, or check with someone which is familiar with just how to spray on auto paint

Step F:

You are down to the finishing touches once you are absolutely satisfied with the shade. You may now want to apply several clear coatings. This will give the finished and gloss appearance to the car together with protect the finish. Probably two coatings will be sufficient but it'll be up to you. Make absolutely sure it's dry in between coats.



Step G:

Once again, you've got the option of wet sanding if you prefer. Again, I suggest you ask the guidance of individuals which can be familiar with the way to paint an automobile. You need to wet sand with these grits in this sequence if you determine to follow this step then. Use 800, 1000, 1200, 1500 and the finally the 2000. This will remove spots that'll not be overly light in the clear coat application.

Step H:

Now you'll desire to using a rubbing compound to buff the surface in order to use a 2000 grit to remove any scratches.

Step I:

You should now buff the surface. To do this just use a moderate cut polish. Once this has been done by you, you should have a perfect glassy look to the finish.

Step J:

As a final touch, you may want to apply a number of layers of wax.

Comments (0)

Add Comment
Comments Options
Sort comments by:





blog archive


get in touch

You must login or register in order to get in touch.