11 Measures to Spray Paint Your Car Like the Professionals - Automobile Bodywork Paint Repair - measlycoffin094's Blog



11 Measures to Spray Paint Your Car Like the Professionals - Automobile Bodywork Paint Repair


You may be surprised to find just the way to spray on auto paint actually can not be difficult. That does not mean that you go at it and can only grab a tin of paint. There are some basics you need to understand. Both in the preparation and application.

Step A:

Prepare by assembling all of your items that you're going to need. Be sure your surrounding area is protected against any possible over aerosol. For other regions cover well with paper and masking tape.

Step B:

You may have to examine the car carefully for any Alloy Wheel Repair Enfield rough spots. In addition, it enables the aerosol automobile paint to stick better. Make certain all of the dust dirt and debris are taken off the vehicle once you have finished sanding. It is imperative that the car be absolutely clean.

Step C:

You will need to apply a primer. This will make sure you get an overall even coating of your colored paint plus helps the paint to stick nicely. Be sure to allow for drying in between and apply light layers when you spray the primer. The way to spray on car paint requires a little getting used to.

Step D:

Now you are well to the point where you happen to be about ready to spray on the shade. Either way, make a couple of practice strokes on an item before you begin with the auto. Once you are ready, start the passes with the paint without reluctance. If you hold gun or the spray can in one area, you will get uneven coverage and perhaps the paint will run. If this happens you have a major repair job on your had. You will most likely have instructions regarding the best way to spray car paint using the gear or spray cans.

Step E:

It is up to you whether you desire to wet sand between coats of primer and colour paints. Check with someone that's comfortable with just how to spray car paint, or you might want to research this choice on the web

Step F:

You're down to the finishing touches, once you're absolutely satisfied with the shade. You may now want to apply several coats that are clear. This can give the polish and finished look to the auto as well as protect the finish. It will be up to you although likely two coatings will be adequate. Make absolutely sure it's dry in between coats.

Step G:

If you favor once again, you have the alternative of wet sanding. Again, I would recommend you request the advice of individuals which are comfortable with how to paint an automobile. If you decide to follow this step subsequently you need to wet sand with the following grits in this order. Use 800, 1000, 1200, 1500 and the finally the 2000. This will remove spots that may be overly heavy in the clear coat application.

Step H:

Step I:

You should buff the surface. To do this just use a medium cut polish.

Step J:

As a final touch, you might want to apply a couple of layers of wax.

Comments (0)

Add Comment
Comments Options
Sort comments by:

blog archive

get in touch

You must login or register in order to get in touch.